1. It can be used repeatedly: the product is made of high quality
waterproof glue. It is suitable for indoor and outdoor use. The surface
covering phenolic resin film has the characteristics of wear resistance,
corrosion resistance and high strength.
2, easy to use: smooth surface, smooth, easy to release, and easy to
surface treatment after casting, cancel the two plastering operation,
shorten the decoration operation time limit.
3, low thermal conductivity, conducive to winter construction insulation.
The use of van solid
Clear water formwork is suitable for horizontal formwork, shear wall,
vertical wallboard, bridge, dam and tunnel and beam column in high-rise
building.
Saw cutting plate
A saw with a guide rail with a diameter of 300 mm and 100 teeth is used, so as to keep the cutting edge straight. The speed is 4000 revolutions per minute. If the irregular geometry is required, the high-speed saw can be cut on the spot. In order to prevent burrs, the boards should be laid down when sawing and drilling.
Edge sealing coating
The
clear water plate has been sealed before leaving the factory. Please
cut or drill the hole three times with waterproof phenolic paint. If the scratch, bruise or other minor damage is found on the surface of the template, the phenolic paint shall be brushed.
Template use
The wooden side close to the template shall be laid lengthwise. Seam narrow as far as possible, between the board and the board should be smooth. Wooden specifications of 5cmX10cm or 10cmX10cm, seam putty block, or
sealed with tape, to prevent leakage and pollution of pulp board edge,
no collision with hard objects, crowbar and reinforced the surface drag
on. 1, top die: first in the scaffolding on the transverse paving wooden
mold, spacing of 1.2m, then the vertical spread batten spacing is
0.4-0.6m, the Quan pouring thickness of more than 2OOmm, the distance
should be appropriately small. 2, the first longitudinal wall template laying three batten, then cross
shop two batten wall screws connection, stay well position, standing,
conditional transverse by steel columns are connected to form a combined
wall template, can be directly lifted, removable single block template. 3. Beam and column mould: cut the template according to size and reserve the through wall bolt position. The column die can be locked with four short scaffold and erect upright brace.
Treated surface
A release agent shall be applied to the surface of the
template before use so as to release and clean the surface, prolong the
service life of the formwork and improve the surface quality of the
concrete.
Storage code stack
After removing the template, immediately with the brush,
plastic or wooden scraper and other non metal tools after cleaning,
bedding wood, stacking corners aligned on a flat surface, surface shall
not be in direct contact with the surface to keep the template.
